Filter
Top Products
NAMES AND
FUNCTIONS
12
BASIC
CONNECTIONS
BASIC
OPERATION
ADVANCED
CONNECTIONS
SETUP
ADVANCED
OPERATION
TROUBLESHOOTING
OTHERS
BASIC
CONNECTIONS
BASIC
OPERATION
ENGLISH
BASIC CONNECTIONS
CONNECTING THE ANTENNAS
CONNECTING THE SUPPLIED ANTENNAS
The supplied antennas are for indoor use only.
GND
GND
AM
AM
ASSEMBLING THE AM LOOP ANTENNA
Insertting the tabs into the base as shown.
CONNECTING THE AM ANTENNA CABLE
Press and hold Insert wire Release
WhiteBlack
Notes
• During use, extend the FM antenna and move it in various directions until the clearest sound is received.
Fix it with push pins or similar implements in that cause the least amount of distortion.
• Set in the direction and position it to where you receive the clearest sound. Put it as far away as possible from
the unit, televisions,speaker cables and power cable.
CONNECTING AN OUTDOOR ANTENNAS
If you experience poor reception quality, an outdoor antenna may improve the quality.
Keep the antenna from noise sources (neon signes, busy roads, power lines, transformers, etc)
FM
FM
(
(
75
75
Ω
Ω
)
)
GND
GND
AM
AM
FM External
Antenna
AM Loop Antenna
Black White
Ground
AM External
Antenna
16 to 32ft (5 to 10m)
Vinyl-coated wire
Notes
• Do not remove the AM loop antenna.
• Do not connect the supplied FM antenna.
• The GND terminal on this unit does not function as a safety ground.
CONNECTING OF AC POWER CABLE
1. Plug the supplied AC power cable to the
AC IN socket on the rear panel of the main
unit.
AC IN
2. Plug the power cable into an AC outlet.
AMP OPERATION
TURNING ON THE UNIT
1. Connect the AC power cable to the wall
outlet.
2. Turn the power on to other units connected
to this unit.
3. Press the POWER ON/STANDBY button of
this unit. Every time the button is pressed,
the power to this unit toggles between on
and standby.
To activate power using the remote
controller, press the AMP button, followed
by the ON button and SOURCE ON/OFF
button of the remote controller.
BASIC OPERATION