Filter
Top Products
16
17
On-screen Display (continued)
Time code (TC) display
( : ) NDF
( . ) DF
• Use the menu to display the time code for HD-SDI signal input.
It also allows you to switch display mode (LTC, VITC, LUB,
VUB). (→page 40)
In VITC and LTC display mode:
• Displays the time code as follows.
hours: minutes: seconds: frames
• In drop-frame mode, a different delimiter between seconds and
frames is used.
<Note>
Read errors are displayed as “--:--:--:--”
In VUB and LUB display modes:
• BG8, BG7, BG6, BG5, BG4, BG3, BG2, BG1 appear in the
stated order.
BG: binary group
• The (:) delimiter does not appear.
<Note>
Read errors are displayed as “-- -- -- --”
Closed caption (CC) display
display area
Closed caption
display area
Closed caption
(When the specified window extends out of the entire screen)
• Closed caption can be displayed when SDI signals and
VIDEO signals are input.
• Closed caption complies with the following standards.
• Composite Standard EIA/CEA-608 (VBI), OP-42
• SD-SDI CC Standard EIA/CEA-608 (ANC/VBI), OP-42
• HD-SDI CC Standard EIA/CEA-608 (708), EIA/CEA-708,
OP-47
• In the case of EIA/CEA-708, multiple windows can be displayed
at specified positions (up to 8).
• The display position is within a display area that is located in-
side the entire screen. (Refer to the following notes.)
• The display settings can be configured in the menus. You can
also select the type of closed caption, display channel (EIA/
CEA-608), and display service (EIA/CEA-708) in the menus.
(→page 40)
<Note>
• The specified window position is displayed as a position within
the display area depending on the closed caption information.
• The window may extend out of the display area depending on
the specified window position and size. In such a case, the win-
dow will be displayed but if the window also extends out of the
entire screen, the display position of the window will be changed
so that the window is displayed inside the entire screen.
In monitor display (IMD) display
CAM1
Tally-1 Tally-2Text
• This monitor supports the TSL UMD PROTOCOL (Ver. 3.1 and
Ver. 4.0) and allows you to display text and the tally indication
on the monitor using the RS-485 interface.
• For information on how to set IMD and communications, refer
to pages 41 and 46.