Filter
Top Products
34
35
Main menu (continued)
WFM/VECTOR
The WFM/VECTOR function enables display of the waveform and vector display. Use DISPLAY SETUP in the main menu to select
WFM and VECTOR display. (→page 40)
Press the button ([FUNCTION1] to [FUNCTION5] (→page 11)) to which the WFM/VECTOR function has been assigned to switch the
display in the following order.
WFM/VECTOR OFF → WFM Y ON → WFM R ON → WFM G ON → WFM B ON → VECTOR (x1 to x8)
• This assumes that the WFM/VECTOR function has been assigned to any of the [FUNCTION1] to [FUNCTION5] buttons.
WFM is displayed in the order of the Y signal, R signal, G signal, and B signal.
Normal screen
WFM display
(Y→R→G→B)
VECTOR display
*
9
Press the
button again
Press the
button again
WFM (waveform
display)
VECTOR
(vector display)
These examples show 16:9 aspect ratio images.
*
9
Displayed only for SDI signal input.
• The scale display is as shown below.
100 %
This dotted line is 109%.
A dotted line indicates for
each 10% increase.
This dotted line is -4%.
I axis
Q axis
The frame is ±2.5 degrees, ±2.5 %
50 %
0 %
Press the FUNCTION button to which the WFM/VECTOR function has been assigned.