Filter
Top Products
33
34
CQ-VX220W
English
Settings (continued)
RadioDiscSoundScreen
Basic Setting
w
Touch and hold until “Completed!” is displayed.
The ID code cancelling procedure is completed. The unit
now works without an ID code.
Note:
¡
Should your unit ever require service, cancel your ID
code before sending for repair.
¡The ID code setting cannot be eliminated even by the
memory clear function.
¡The inputted code is not displayed for your security.
Clock
Clock setting
: clock display ON (“– –:– –” is displayed
before adjusting the clock.)
: clock display OFF
default:
: Forward
: Backward
Note:
¡
To start the clock, touch .
¡
Set the Daylight Saving Time manually.
default: Hour Adjust: 00
Minute Adjust: 00
ID-Code
ID Code Setting
Prior to operating this unit, it is advisable to assign a 4-
digit ID code for security. Once the ID code has been set,
the unit cannot be operated if the main power supply is
disconnected then re-connected. It is electronically locked
so that a thief cannot use the stolen unit unless that per-
son knows the code you have set.
The ID code operation must be performed only by the
person to whom the unit belongs.
Generally, it is not necessary to enter the ID code each
time when using the unit if it has not been disconnected
from the main power supply (car battery).
to 4 digits numeric code
default: none
How to set your ID code (for the first time)
q Enter an 4 digit ID code.
w Enter the same 4 digit ID code again.
How to change your ID code
q Enter the preset (old) 4 digit ID code. If the wrong ID
code is entered, a new ID code cannot be registered.
w Enter a new 4 digit ID code.
e Enter the new 4 digit ID code again.
How to cancel the known ID code
q
Enter the preset (old) 4 digit ID code. If the wrong ID code
is entered, it is not possible to cancel the ID code function.
90
{
}
(Clock adjustment)
Adjust
Off
Off
On
(Clock display)
Display
Caution
¡Record your registered ID code and keep it in a
secure location. (Fill in the ID code memo
(a page 46).) If you forget it, you will be unable
to use the unit. In case you forget the ID code,
please consult your nearest Panasonic Service
Center.
Input
Input selection
Note:
¡
If a non-Panasonic navigation system is connected to
this unit, we do not guarantee the operations of the
navigation system.
: an external device is connected to AV1.
: skips AV1.
default:
: an external device is connected to AV2.
: Select one from among NAV1, NAV2, and
NAV3 with which images are displayed
most beautifully when a non-Panasonic
car navigation system is connected.
: skips AV2.
default:
Selection of the terminal that connects to the rear view
camera.
Preparation: Connect the reverse lead. (
a Installation
Instructions)
: connected to the CAMERA IN
: unconnected
default:
Off
Off
On
(Rear view camera set up)
Camera
AV2
Skip
NAV1-3
AV2
(AV2 input selection)
AV2
AV1
Skip
AV1
(AV1 input selection)
AV1