Filter
Top Products
5
Before Use
∏ Remote Control∏ Operating Instructions
∏ Satellite Receiver List
∏ RF lead to connect VCR
and TV
1
2
-
-
+
+
3
Checking the Accessories/Preparing the Remote Control
Inserting Remote Control Batteries
1 Slide off the battery cover.
2 Insert the batteries with the
polarity (+ and -)
correctly aligned.
3 Replace the battery cover.
≥ Do not heat or short-circuit the batteries.
≥ When you do not use the remote control for a long time,
take out the batteries and store them in a cool, dry
place.
If the Sliding Cover of the Remote
Control Becomes Detached
If the sliding cover of the remote control becomes
detached accidentally, fit it securely in place by placing it
on the top of the remote control at the position shown in
the illustration below, and pushing it down until it clicks
into position.
≥ It is not possible to fit the sliding cover in place by
pushing or sliding it on from the bottom end of the
remote control.
Notes for Battery Replacement:
≥ The service life of the batteries is approximately 1 year.
However, it varies considerably depending on the
frequency of use.
≥ When they are exhausted, replace them with two AA,
UM3, or R6 size batteries.
≥ When the batteries are exhausted, remove them
immediately and dispose of them correctly.
≥ Make sure that the batteries are inserted with the
polarity (+ and -) correctly aligned.
≥ Do not mix old battery with new battery.
≥ Do not mix different battery types, i.e. Alkaline and
Manganese.
≥ Do not use rechargeable (Ni-Cd) batteries.
Check that you have the accessories shown below .
∏ Batteries for the Remote Control
∏ AC Mains lead
WrongCorrect