Filter
Top Products
Using voice recognition to
operate this unit
Important
In this section, voice recognition operation is illu-
strated in English.For about languages other
than English, please refer to enclosed command
list. Also, supported commands are shown in the
list.
You can use voice recognition to perform op-
erations such as the following.
! Input a phone number, and make a call.
! Input a name stored in the phonebook and
make a call.
! Input a name and type stored in the phone-
book, and make a call.
! Access Help.
! Perform voice recognition again.
1 Press VOICE/
to start voice recogni-
tion.
The audio sound is muted, and a beep tone
sounds.
2 When you hear Voice Command,
please. and a beep tone, say a voice com-
mand.
3 Perform the operation in accordance
with the voice guidance.
Notes
! To cancel voice recognition partway through,
say cancel or abort or press SRC/OFF,
BAND/ESC/CANCEL,or
.
! When you want to return to the state immedi-
ately after voice recognition was started, say
Restart after you hear the beep tone to return
to the stateof Step 2.
! If a voice command is said incorrectly, an
error occurs and the unit waits for a voice
command to be said. Say a correct voice com-
mand.
! If you are unsure of a voice command,say
Help or Whatcan I say? to play the help
voice guidance.
! Voice recognition is possible when any of the
sources is selected, but a call can only be
made when a cellular phone is connected.
Refer to page 28,and check whether a cellular
phone is connected to this unit correctly. If a
voice command is said when no cellular
phone is connected, an error occurs and the
unit waits fora voice command to be said.
Connect a cellular phone and say a correct
voice command.
! For a list of voice commands, refer to the next
page.
! When no voice command is spoken for 8 sec-
onds, a beep tone and Cancel is heard, and
voice recognition returns to the ordinary dis-
play.
! Operation varies depending on the type of cel-
lular phone. Refer to the instruction manual
that came with your cellular phone for de-
tailed instructions.
Using voice recognition to
make a call
You can use voice recognition to make a call.
This explanation uses the example of making
a call to 0123456789.
1 Start voice recognition.
Refer to Using voice recognition on this page.
2 Say Dial 0123456789.
3 Say Dial.
4 A call is made to the number read out.
Notes
! A phone number of up to 30 digits long can
be read out. If a phone number that exceeds
30 digits is input, an error occurs and theunit
waits for a voice command to be said. Say a
correct voice command.
Using voice recognition
En
40
Section
09