Filter
Top Products
Black plate (19,1)
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Press AUDIO to select LOUD.
2 Press a to turn loudness on.
Loudness level (e.g., LOUD:MID) appears in
the display.
# To turn loudness off, press b.
3 Press c or d to select a desired level.
LOW (low)—MID (mid)—HI (high)
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off.
1 Press AUDIO to select SUB.W.
# You canalso select the subwoofersetting
menu by pressingSW on the unit.
# When the subwoofercontroller setting is
P/O:FUL, youcannot select SUB.W.
2 Press a to turn subwoofer output on.
SUB.W:NOR appears in the display. Subwoo-
fer output is now on.
# If the subwoofer output phasehas been set to
the reverse, SUB.W:REVwill be displayed.
# To turn subwooferoutput off, press b.
3 Press c or d to select the phase of sub-
woofer output.
Press c to select reverse phase and REV ap-
pears in the display. Press d to select normal
phase and NOR appears in the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Press AUDIO to select 80: 0.
# You canalso select the subwoofersetting
menu by pressingSW on the unit.
# When the subwooferoutput is on,you can se-
lect 80: 0.
# If the subwoofer setting hasbeen previously
adjusted, the frequencyof that previously se-
lected will bedisplayed instead of 80.
2 Press c or d to select cut-off frequency.
50—63—80—100—125 (Hz)
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.
3 Press a or b to adjust the output level
of the subwoofer.
+6 to –24 is displayed as the level is increased
or decreased.
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn on the
HPF (high pass filter). Only frequencies higher
than those in the selected range are outputted
from the front or rear speakers.
1 Press AUDIO to select HPF.
# When the F.I.E. function is on, youcannot se-
lect HPF.
2 Press a to turn high pass filter on.
HPF: 80 appears in the display. High pass fil-
ter is now on.
# If the high passfilter has been previouslyad-
justed, the frequencyof that previously selected
will be displayedinstead of HPF:80.
# To turn high passfilter off, pressb.
3 Press c or d to select cut-off frequency.
50—63—80—100—125 (Hz)
Only frequencies higher than those in the se-
lected range are outputted from the front or
rear speakers.
<YRD5079-A/U>19
Audio Adjustments
En
19
English
Section
06