Filter
Top Products
Black plate (22,1)
Switching the auxiliary setting
Auxiliary equipments connected to this unit
can be activated individually. Set each AUX
source to ON when using. About connecting
or using auxiliary equipments, refer to Using
the AUX source on this page.
1 Press FUNCTION to select AUX1/AUX2.
2 Press a or b to turn AUX1/AUX2 on or
off.
Setting the rear output and
subwoofer controller
This unit’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (R-SP:FUL) or subwoofer
(R-SP:S/W) connection. If you switch the rear
output setting to R-SP:S/W, you can connect
a rear speaker lead directly to a subwoofer
without using an auxiliary amp.
Initially, the unit is set forrear full-range speak-
er connection (R-SP:FUL). When rear output is
connected to full range speakers (when
R-SP:FUL is selected), you can connect other
full range speakers (P/O:FUL) or a subwoofer
(P/O:S/W) to the RCA rear output.
1 Press FUNCTION to select R-SP.
2 Press a or b to switch the rear output
setting.
Pressing a or b will switch between
R-SP:FUL (full-range speaker) and R-SP:S/W
(subwoofer) and that status will be displayed.
# When no subwooferis connected to therear
output, select R-SP:FUL.
# When a subwoofer is connectedto the rear
output, set forsubwoofer R-SP:S/W.
# When the rearoutput setting is R-SP:S/W,
you cannot operatethe following procedure.
3 Press c or d to switch the subwoofer
output or rear output.
Pressing c or d will switch between P/O:S/W
and P/O:FUL and that status will be displayed.
Notes
! Even if you changethis setting, there isno
output unless youturn the subwoofer output
on (refer toUsing subwoofer output on page
19).
! If you change thissetting, subwoofer output
in the audiomenu return to thefactory
settings.
Turning the clock display
on or off
You can turn the clock display on or off.
% Press CLOCK to turn the clock display
on or off.
Each press of CLOCK turns the clock display
on or off.
# The clock displaydisappears temporarily
when you perform otheroperations, but the clock
display appears againafter 25 seconds.
Note
Even when thesources are off, the clock display
appears on thedisplay. Pressing CLOCK turns
the clock displayon or off.
Using the AUX source
This unit can control up to two auxiliary equip-
ments such as VCR or portable devices (sold
separately). When connected, auxiliary equip-
ments are automatically read in as AUX
sources and assigned to AUX1 or AUX2. The
relationship between AUX1 and AUX2
sources is explained below.
<YRD5079-A/U>22
Other Functions
En
22
Section
07