Filter
Top Products
Initial (initial)—Custom (custom)—Auto TA
(auto-time alignment)—TA OFF (off)
! Initial is thefactory supplied time align-
ment.
! Custom is anadjusted time alignment that
you can createfor yourself.
! Auto TA is the timealignment created by
auto TAand EQ. (Refer toAuto TA and EQ
(auto-time alignment andauto-equalizing)
on page 59.)
# Please set AutoTA appears.This indicates
that you cannotselect Auto TA if auto TA and EQ
has not beencarried out.
Adjusting the time alignment
You can adjust the distance between each
speaker and the selected position.
! An adjusted time alignment is memorized
in Custom.
1 Use MULTI-CONTROL to select TA 1.
TA1 appears in the display.
2 Press MULTI-CONTROL to select a unit
of distance.
Each press of MULTI-CONTROL selects the
unit of distance in the following order:
(cm) (centimeter)—(inch) (inch)
3 Use MULTI-CONTROL to select TA2.
TA2 appears in the display.
# Can't Adjust TA. Set POS FL/FRappears
when neither Front Leftnor Front Rightis se-
lected in theposition selector mode (POSI).
# When selecting TA OFF in TA1, you cannot
switch to TA2.
4 Push MULTI-CONTROL left or right to
select the speaker to be adjusted.
Each time MULTI-CONTROL is pushed left or
right, the speaker is selected in the following
order:
Hi L (high-range left)—Hi R (high-range right)
—Mid L (middle-range left)—Mid R (middle-
range right)—Low L (low-range left)—Low R
(low-range right)
Front L (front left)—Front R (front right)—
Rear R (rear right)—Rear L (rear left)—
SubW. L (subwoofer left)—SubW. R (subwoo-
fer right)
# You cannotselect SubW. L and SubW. R
when the subwooferoutput is off.
5 Push MULTI-CONTROL up or down to
adjust the distance between the selected
speaker and the listening position.
Each time MULTI-CONTROL is pushed up or
down, the distance increases or decreases.
400.0cm to 0.0cm is displayed as the distance
is increased or decreased, if you have selected
centimeters ((cm)).
160inch to 0inch is displayed as the distance
is increased or decreased, if you have selected
inches ((inch)).
# You canadjust the distancefor the other
speakers in thesame way.
6 Press BAND to cancel the time align-
ment mode.
About the network
function
The network function lets you divide the audio
signal into different frequency bands, and
then reproduce each of them through sepa-
rate speaker units.
Audio Adjustments
En
51
English
Section
11