Filter
Top Products
Black plate (14,1)
Listening to the radio
4
4
4
4
3
3
3
3
5
5
5
5
2
2
2
2
1
1
1
6
6
6
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on the next page.
Important
If you are using thisunit in North, Central or
South America, resetthe AM tuning step (see
Setting the AM tuningstep on page 60).
1 Stereo(5) indicator
Shows when the selected frequency is
being broadcast in stereo.
2 LOCindicator
Shows when local seek tuning is on.
3 Bandindicator
Shows which band the radio is tuned to, AM
or FM.
4 Presetnumber indicator
Shows which preset has been selected.
5 Frequencyindicator
Shows the frequency to which the tuner is
tuned.
6 Signallevel indicator
Shows the radio wave strength.
1 Press SOURCE to select the tuner.
Press SOURCE until you see Tuner displayed.
2 Press BAND to select a band.
Press BAND until the desired band (FM-1,
FM-2, FM-3 for FM or AM) is displayed.
3 To perform manual tuning, push
MULTI-CONTROL left or right.
The frequencies move up or down step by
step.
4 To perform seek tuning, push and hold
MULTI-CONTROL left or right for about one
second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You cancancel seek tuning by pushing
MULTI-CONTROL left or right.
# If you push and holdMULTI-CONTROL left or
right you can skipstations. Seek tuning starts as
soon as you releaseMULTI-CONTROL.
<CRD4089-A/N>14
Tuner
En
14
Section
04