Filter
Top Products
Black plate (52,1)
–12— –6—Pass (0) (dB/oct.)
# If you set the slopeto 0 dB/oct. (Pass), the
audio signal bypassesthe filter, so the filter does
not have an effect.
3 Turn MULTI-CONTROL to select
Front HPF FREQ.
Front HPF FREQ. appears in the display.
4 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each time MULTI-CONTROL is pushed left or
right, cut-off frequencies are selected in the
following order:
50—63—80—100—125—160—200 (Hz)
Only frequencies higher than those in the se-
lected range are output from the front speak-
ers.
5 Push MULTI-CONTROL up or down to
adjust the output level of the front speak-
ers.
Each time MULTI-CONTROL is pushed up or
down, the level of the front speakers increases
or decreases. 0 to –24 is displayed as the level
is increased or decreased.
Setting the high pass filter for
rear speakers
1 Use MULTI-CONTROL to select
Rear HPF.
Rear HPF appears in the display.
2 Push MULTI-CONTROL left or right to
select slope.
Each time MULTI-CONTROL is pushed left or
right, slopes are selected in the following
order:
–12— –6—Pass (0) (dB/oct.)
# If you set the slopeto 0 dB/oct. (Pass), the
audio signal bypassesthe filter, so the filter does
not have an effect.
3 Turn MULTI-CONTROL to select
Rear HPF FREQ.
Rear HPF FREQ. appears in the display.
4 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each time MULTI-CONTROL is pushed left or
right, cut-off frequencies are selected in the
following order:
50—63—80—100—125—160—200 (Hz)
Only frequencies higher than those in the se-
lected range are output from the rear speak-
ers.
5 Push MULTI-CONTROL up or down to
adjust the output level of the rear speak-
ers.
Each time MULTI-CONTROL is pushed up or
down, the level of the rear speakers increases
or decreases. 0 to –24 is displayed as the level
is increased or decreased.
Using the auto-equalizer
The auto-equalizer is the equalizer curve cre-
ated by auto TA and EQ (refer to Auto TA and
EQ (auto-time alignment and auto-equalizing)
on page 56).
You can turn the auto-equalizer on or off.
1 Use MULTI-CONTROL to select Auto EQ.
Auto EQ appears in the display.
# Please set AutoEQ appears. This indicates
that you cannot turnthe auto-equalizer on if auto
TA andEQ has not been carried out.
2 Press MULTI-CONTROL to turn the auto-
equalizer on.
ON appears in the display.
# To turn auto-equalizer off, press
MULTI-CONTROL again.
<CRD4089-A/N>52
Audio Adjustments
En
52
Section
11