Filter
Top Products
DIN Rear-mount
1 Determine the appropriate position
where the holes on the bracket andthe
side of the unit match.
2 Tighten two screws on each side.
1
2
3
1 Mountingsleeve
2 Mountingbracket
3 Dashboard or console
Use either truss (5 mm × 8 mm)or flush sur-
face (5 mm × 9 mm) screws, depending on
the bracket screw holes.
Removing the unit
1 Remove the trim ring.
1
1 Trimring
! Releasing thefront panel allowseasier ac-
cess to thetrim ring.
! When reattachingthe trim ring, pointthe
side with thegroove down.
2 Insert the supplied extraction keys into
both sides of the unit until they click into
place.
3 Pull the unit out of the dashboard.
Securing the front panel
The front panel can be secured with thesup-
plied screw.
1
1 Screw
Speaker installation
1
1
2
3
Front
1 45°
2 4.3mm holes (3/16 in.Dia.)
3 f142 mm (5-5/8 in.Dia.)
En
13
English
Section
03
Installation