Filter
Top Products
5 Touch to turn the panorama control
on.
# To turnthe panorama control off, touch .
6 Touch and then touch or to ad-
just front/surround speaker balance.
Each time you touch
or it moves the
sound towards the front or the surrounds.
+3 3 is displayed as the front/surround
speaker balance moves from front to sur-
rounds.
7 Touch
and then touch or to ad-
just the center image.
Each time you touch
or it gradually
spreads the center channel sound into the
front left and right speakers over a range 07.
3 is the default and its recommended for
most recordings. 0 places all center sound in
the center speaker. 7 places all center sound
equally in the left/right speakers.
Setting the speaker setting
You need to make with/without (or yes/no) and
size (bass reproducing capacity) selection/ad-
justments depending on the installed speak-
ers. The size needs to be set to LARGE (large)
if the speaker is capable of reproducing
sounds of about 100 Hz or below. Otherwise
select SMALL (small).
! Low frequency range is not output if the
subwoofer is set to OFF and the front and
rear speakers set to SMALL or OFF.
! It is imperative that non-installed speakers
be set to OFF.
! Set the front or rear speaker to LARGE if
the speaker is capable of reproducing bass
content, or if no subwoofer is installed.
1 Touch A.MENU and DSP and then touch
NEXT.
2 Touch SPEAKER SETTING.
3 Touch
or to select the speaker to
be adjusted.
Each time you touch
or selects the
speaker in the following order:
FRONT (front speakers)CENTER (center
speaker)REAR (rear speakers)
SUB WOOFER (subwoofer)PHASE (sub-
woofer setting)
# You can switchto PHASE only whenthe sub-
woofer has beenset to ON.
4 Touch or to select the correct size
for the selected speaker.
Each time you touch
or selects the size
in the following order:
OFF (off)SMALL (small)LARGE (large)
# You cannot selectOFF, when FRONT (front
speakers) have beenselected.
# You can selectON or OFF, when
SUB WOOFER (subwoofer) has beenselected.
# You can switchREVERSE (reverse phase) or
NORMAL (normalphase), when PHASE(subwoo-
fer setting) hasbeen selected.
Correcting the subwoofers phase
If trying to boost the bass output of the sub-
woofer doesnt do much or rather makes you
feel that the bass gets more murky, this may
indicate that the subwoofers output and bass
content you hear over other speakers cancel
each other out. To remove this problem, try
changing the phase setting for the subwoofer.
1 Touch A.MENU and DSP and then touch
NEXT.
2 Touch SPEAKER SETTING.
Digital Signal Processor
En
12
Section
03