Filter
Top Products
conditioner or heater may prevent correct auto
TA and EQ.
# Press SOURCE toturn the source onif this
unit is turnedoff.
4 Select the position for the seat on
which the microphone is placed.
Refer to Using the position selector on page 9.
# If no positionis selected before youstart auto
TA and EQ, FRONT-L isselected automatically.
5 Press SOURCE and hold until the unit
turns off.
6 Press and hold EQ to enter the auto TA
and EQ measurement mode.
7 Plug the microphone into the micro-
phone input jack on this unit.
8 Touch START to start the auto TA and
EQ.
9 Get out of the car and close the door
within 10 seconds when the 10-second
count-down starts.
The measurement tone (noise) is outputted
from the speakers, and auto TA and EQ be-
gins.
# When all speakers are connected, auto TA
and EQ iscompleted in about nineminutes.
# To stopauto TA and EQ, touchSTOP.
# To cancelauto TA and EQ partway through,
touch BACK orESC.
10 When auto TA and EQ is completed,
Complete is displayed.
When correct measurement of car interior
acoustic characteristics is not possible, an
error message is displayed. (Refer to Under-
standing auto TA and EQ error messages on
page 22.)
11 Touch ESC to cancel the auto TA and EQ
mode.
12 Store the microphone carefully in the
glove compartment.
Store the microphone carefully in the glove
compartment or any other safe place. If the
microphone is subjected to direct sunlight for
an extended period, high temperatures may
cause distortion, color change or mal-
function.
Digital Signal Processor
En
19
English
Section
03