Filter
Top Products
Introduction of DSP
adjustments
1
By carrying out the following settings/adjust-
ments in the order shown, you can create a fi-
nely-tuned sound field effortlessly.
1 Setting thespeaker setting
2 Using theposition selector
3 Auto TA andEQ (auto-time alignment andauto-
equalizing)
4 Adjusting thetime alignment
5 Adjusting thespeaker output levels using a
test tone
6 Selecting across-over frequency
7 Adjusting thespeaker output levels
8 Adjusting 3-bandparametric equalizer
1 DSP display
Shows the DSP function names.
% Touch A.MENU and then touch DSP to
display the DSP function names.
The DSP function names are displayed and
operable ones are highlighted.
# When A.MENU isnot displayed, you candis-
play it bytouching the screen.
# You can alsodisplay MENU by clickingthe
joystick.
# To goto the next groupof function names,
touch NEXT.
# To returnto the previous groupof function
names, touch PREV.
# When playing discsrecorded with morethan
96 kHz samplingfrequency, you cannotuse audio
functions. Also,equalizer curve setting,
POSITION, AUTO EQand AUTO TA will be can-
celled.
# When playing discsrecorded with morethan
96 kHz samplingfrequency, audio is outputted
from front speakeronly.
# When selecting theFM tuner as thesource,
you cannot switchto SLA.
# When playing otherthan the DVD disc, you
cannot switch toD.R.C.
# When neither FRONT-L norFRONT-R is se-
lected in POSITION, you cannotswitch to
TIME ALIGNMENT.
# To returnto the previous display, touchBACK.
# To returnto the display ofeach source, touch
ESC.
Note
If you do notoperate the DSP function within
about 30 seconds,the display is automatically re-
turned to thesource display.
Using the sound field control
The SFC function creates the sensation of a
live performance.
! The acoustics of different performance en-
vironments are not the same and depend
on the extent and contour of space through
which sound waves move and on how
sounds bounce off the stage, walls, floors
and ceilings. At a live performance you
hear music in three stages: direct sound,
early reflections, and late reflections, or re-
verberations. Those factors are programed
into the SFC circuitry to recreate the acous-
tics of various performance settings.
1 Press EQ and hold to switch to SFC
function.
Press EQ and hold until SFC appears in the
display.
Digital Signal Processor
En
8
Section
03