Filter
Top Products
2 Touch SP Lev.
3 Touch
or to select the speaker to
be adjusted.
Each time you touch
or selects the
speaker in the following order:
FRONT-L (front speaker left)CENTER (center
speaker)FRONT-R (front speaker right)
REAR-R (rear speaker right)REAR-L (rear
speaker left)SUB WOOFER (subwoofer)
# You cannot selectspeakers whose size isset
at OFF.
4 Touch or to adjust the speaker
output level.
Each time you touch
or increases or de-
creases the speaker output level. +10 10 is
displayed as the level is increased or de-
creased.
Note
To adjustthe speaker output levelsin this mode is
the same as making the speakeroutput levels at
TEST TONE. Both providethe same results.
Adjusting the speaker output
levels using a test tone
A convenient test tone allows you to easily get
the overall balance right among the speakers.
1 Touch A.MENU and DSP and then touch
NEXT.
2 Touch TEST TONE.
3 Touch START to start the test tone out-
put.
The test tone is outputted. It rotates from
speaker to speaker in the following sequence
at intervals of about two seconds. The current
settings for the speaker over which you hear
the test tone are shown in the display.
FRONT-L (front speaker left)CENTER (center
speaker)FRONT-R (front speaker right)
REAR-R (rear speaker right)REAR-L (rear
speaker left)SUB WOOFER (subwoofer)
Check each speaker output level. If no adjust-
ments are needed, perform step 5 to stop the
test tone.
# You can alsostart the test toneoutput by mov-
ing the joystickup.
# The settings donot appear for speakers
whose size isset OFF.
4 Touch or to adjust the speaker
output level.
Each time you touch
or increases or de-
creases the speaker output level. +10 10 is
displayed as the level is increased or de-
creased.
# The test tonerotates to the nextspeaker after
about two secondsfrom the last operation.
5 Touch STOP to stop the test tone out-
put.
# You can alsostop the test toneoutput by mov-
ing the joystickdown.
Notes
! If needed,select speakers andadjust their ab-
solute output levels.(Refer to Adjustingthe
speaker output levels onthe previous page.)
! To adjustthe speaker output levelsin this
mode is thesame as making thespeaker out-
put levels at SP Lev. Bothprovide the samere-
sults.
Using the time alignment
The time alignment lets you adjust the dis-
tance between each speaker and the listening
position.
Digital Signal Processor
En
14
Section
03