Sanyo DC-DAB03 Car Stereo System User Manual


 
-12-
Present time.
TIMER ON time.
TIMER OFF time.
Original preset function.
Original display returns.
To change the timer settings
1. Turn on the power and press the /CLOCK/TIMER button to select
the setting to be changed.
2. Press the MEMORY button so that the display blinks.
3. Change the setting as explained above.
To release the timer
Turn on the power and press the /CLOCK/TIMER button for at least
1 second, “ CANCEL” display briefly.
To set the timer again with the same settings
1. Turn on the power and press the /CLOCK/TIMER button for at
least 1 second till “
ENABLE” appears briefly.
2. Press the z/ON button to switch off the power.
Note:
The timer operation is released if a power failure occurs.
Using the sleep timer (Remote control only)
The sleep timer automatically switches off the power after a preset time
has elapsed. The volume will gradually be reduced (fade-out) during the
1-minute period before the unit turns off. There are 9 time periods available:
90, 80, 70, 60, 50, 40, 30, 20, and 10 minutes.
Press and hold down the SLEEP button to select the desired sleep time.
“SLEEP - ” blinks and selected time appears on the display. After several
seconds, the original display returns.
To release the sleep timer while in operation
Press and hold down the SLEEP button until the “OFF” appears. The
timer is also released if the power is switched off.
MAINTENANCE
Cleaning the unit
Clean the outside of the unit with a clean soft cloth, moistened with
lukewarm water. Do not use benzene, thinner or alcohol since they will
mar the finish of the surfaces.
DAB03UK(En)p11-12-05 05/12/2005, 2:04 PM12