Filter
Top Products
-ā21ā-
TROUBLESHOOTING
Sometimes a simple operational error or a mistake in the wiring can appear to be a problem with
the unit. Before having the unit serviced, refer to the troubleshooting chart below.
Symptom
Cause Solution
The compact disc or tape
does not play when
The volume control is
turned down.
Turn up the volume control.
py
inserted into the unit.
The power connections are
not wired correctly.
Check the +12V and ground
connections.
No power. The vehicle ignition is
switched off.
Switch the ignition to the ON" or
ACC" position.
The fuse is blown. Replace the fuse with another
15A fuse.
The unit does not work
properly (Eject, Load,
)
The microcomputer has
been affected by electrical
Eject the disc or tape, then insert
it again.
pp y(j , ,
Play).
y
noise.
Turn the power off and then on
again.
The sound from the CD
player skips.
The road surface is rough. Wait for the road surface to
improve before playing a disc.
py p
The unit is not mounted
securely.
Install the unit securely. Be sure to
use the rear strap if the vehicle
does not provide support for the
rear of the unit. (See page 24)
The disc is defective. Try another disc.
If it plays properly, the first disc
may be defective.
The disc is dirty. Clean the disc as explained on
pages 3-4.
No radio reception. The antenna cable is not
connected.
Insert the antenna cable firmly
into the antenna jack on the unit.
The radio does not stop on
any stations when
automatic tuning is used.
The signals are weak. Select a station using manual
tuning.