Filter
Top Products
-22-
TROUBLESHOOTING
Sometimes a simple operational error or a mistake in the wiring can appear to be a problem with the unit.
Before having the unit serviced, refer to the troubleshooting chart below.
Symptom Cause Solution
The compact disc does not play
when inserted into the unit.
The volume control is turned
down.
Turn up the volume control.
The power connections are not
wired correctly.
Check the +12V and ground
connections.
No sound is coming out. The speaker code connection is
incomplete.
Check the connection of the
speaker code, and press the
ON/OFF button.
No power. The vehicle ignition is switched
off.
Switch the ignition to the "ON"
or "ACC" position.
The fuse is blown. Replace the fuse with another
15A fuse.
The unit does not work properly
(Eject, Load, Play).
The microcomputer has been
affected by electrical noise.
Eject the disc, then insert it
again.
The sound from the CD player
skips.
The road surface is rough. Wait for the road surface to
improve before playing a disc.
The unit is not mounted
securely.
Install the unit securely.
The disc is defective. Try another disc. If it plays
properly, the first disc may be
defective.
The disc is dirty. Clean the disc as explained on
pages 3-4.
No radio reception. The antenna cable is not
connected.
Insert the antenna cable firmly
into the antenna jack on the
unit.
The radio does not stop on any
stations when automatic tuning
is used.
The signals are weak. Select a station using manual
tuning.