Sanyo FXCD-1350 Car Stereo System User Manual


 
-6-
BATTERY INSTALLATION
Install a lithium battery (CR2025) with the poles facing the correct direction.
BATTERY REPLACEMENT TIMING
When battery power is depleted, the buttons may not be operable.
If the remote controller does not operate, replace the battery and check the operation.
CAUTIONS REGARDING BATTERY
Be sure to follow the instructions to prevent battery leakage, over-heating, ignition, or explosion.
If battery leakage has occurred, wipe the container first, then install a new battery. If the battery solution
contacts the skin, wash off with water completely.
CAUTIONS REGARDING REMOTE CONTROLLER
Do not leave the remote controller in an area exposed to direct sunlight, such as on the dashboard or
steering wheel. The remote controller may deform because of the heat. (Be especially careful of the
dashboard exposed to direct sunlight in the summer, as it will become extremely hot.)
When the vehicle is parked in an area exposed to direct sunlight, remove the remote controller from its
holder and put it in a shaded spot such as the glove box.
Under direct sunlight, signal reception from the remote controller becomes weakens. If this happens, hold
the remote controller close to the signal receptor on the front panel.
Positive pole faces upward.
Do not expose the battery to flame. Do not short circuit, disassemble, or heat the battery.
Do not charge the battery.
Use the specified type battery.
Keep the button-shaped battery away from children to prevent accidental swallowing.
If the battery is swallowed, contact a doctor immediately.
WARNING
Install the battery with the poles facing the correct direction.
When not in use for a long period of time, or if the battery is dead, remove the battery from
the remote controller.
CAUTION