Sharp LB-1085 Car Video System User Manual


 
10
10º 10º
10º
10º
5 m
Remote control sensor
If the remote control fails to operate LCD Monitor functions, replace the batteries in the remote control unit.
1 Open the battery cover.
2 Insert two R-6 (“AA” size) batteries
(supplied with the product).
3 Close the battery cover.
CAUTION
Use manganese or alkaline batteries only.
Improper use of batteries can result in chemical leakage or explosion. Be sure to follow the instructions below.
Do not mix batteries of different types. Different types of batteries have different characteristics.
Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries or cause
chemical leakage in old batteries.
Remove batteries as soon as they are worn out. Chemicals that leak from batteries that come in contact with skin
can cause a rash. If you find any chemical leakage, wipe thoroughly with a cloth.
The batteries supplied with this product may have a shorter life expectancy due to storage conditions.
If you will not be using the remote control unit for an extended period of time, remove batteries from it.
Never attempt to charge non-rechargeable batteries.
Using the Remote Control Unit
Use the remote control unit by pointing it towards the remote control sensor on the LCD Monitor. Objects
between the remote control unit and the remote control sensor may prevent proper operation.
Place the batteries with their terminals corresponding to
the (+) and (-) indications in the battery compartment.
QUICK REFERENCE
Cautions regarding the remote control unit
Do not expose the remote control unit to shock. In
addition, do not expose the remote control unit to
liquids, and do not place in an area with high humidity.
Do not install or place the remote control unit under
direct sunlight. The heat may cause deformation of the
remote control unit.
The remote control unit may not work properly if the
remote control sensor on the LCD Monitor is under
direct sunlight or strong lighting. In such cases, change
the angle of the lighting or the LCD Monitor, or operate
the remote control unit closer to the remote control
sensor.
The POWER indicator on the LCD Monitor should light BLUE indicating you have
power to the LCD Monitor.
If the POWER indicator on the LCD Monitor still does not light up, press POWER on
the remote control to turn the power on.