Sharp LB-1085 Car Video System User Manual


 
5
Turn off the main power and unplug the AC cord from the wall outlet before handling.
Use a soft cloth and gently wipe the surface of the display panel. Using a hard cloth may
scratch the panel surface.
Use a soft damp cloth to gently wipe the panel when it is really dirty.
(It may scratch the panel surface when wiped strongly.)
If the panel is dusty, use an anti-static brush, which is commercially available, to clean it.
To protect the panel, do not use a dirty cloth, liquid cleaners or chemical cloth to clean it, such materials may
damage the panel surface.
To clean the outer cabinet, use the same method. Do not use liquid or aerosol cleaners.
Water and Moisture — Do not use this product near water - for example, near a bath tub, wash bowl, kitchen
sink, or laundry tub; in a wet basement; or near a swimming pool; and the like.
Stand — Do not place the product on an unstable cart, stand, tripod or table. Placing the product on an unstable
base can cause the product to fall, resulting in serious personal injuries as well as damage to the product. Use
only a cart, stand, tripod, bracket or table recommended by the manufacturer or sold with the product.
Selecting the location — Select a place with no direct sunlight and good ventilation.
Ventilation — The vents and other openings in the cabinet are designed for ventilation. Do not cover or block
these vents and openings since insufficient ventilation can cause overheating and/or shorten the life of the
product. Do not place the product on a bed, sofa, rug or other similar surface, since they can block ventilation
openings. This product is not designed for built-in installation; do not place the product in an enclosed place such
as a bookcase or rack, unless proper ventilation is provided or the manufacturer’s instructions are followed.
The Liquid Crystal panel used in this product is made of glass. Therefore, it can break when the product is
dropped or applied with impact. Be careful not to be injured by broken glass pieces in case the panel breaks.
Heat — The product should be situated away from heat sources such as radiators, heat registers, stoves, or
other products (including amplifiers) that produce heat.
The Liquid Crystal panel is a very high technology product with 2,073,600 pixels, giving you fine picture details.
Occasionally, a few non-active pixels may appear on the screen as a fixed point of blue, green or red. Please
note that this does not affect the performance of your product.
Lightning — For added protection for this LCD Monitor equipment during a lightning storm, or when it is left
unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna. This
will prevent damage to the equipment due to lightning and power-line surges.
Power Lines — An outside antenna system should not be located in the vicinity of overhead power lines or other
electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside
antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with
them might be fatal.
To prevent fire, never place any type of candle or ames on the top or near the LCD Monitor.
To prevent fire or shock hazard, do not place the AC cord under the LCD Monitor or other
heavy items.
Do not display a still picture for a long time, as this could cause an afterimage to remain.
To prevent fire or shock hazard, do not expose this product to dripping or splashing.
No objects filled with liquids, such as vases, should be placed on the product.
Installation and Transportation
The installation, removal or transportation of the LCD Monitor must be performed by qualified service personnel.
This product is large and heavy. Installation requires special knowledge and qualifications.
Customers should not attempt to install, remove, or transport the LCD Monitor by themselves.
SHARP shall have no liability for any accidents or damages caused by improper installation or mishandling.
Install the LCD Monitor in a location with minimal vibration and that is strong enough to hold the weight of the
LCD Monitor. Otherwise, the product may fall or topple over, resulting in injury.
Provide enough space around the LCD Monitor so that it can easily be accessed or carried for maintenance.
70
160
Unit: cm
4040
40
40
4040
After installation, be sure to secure and fasten the LCD Monitor so that it does not move.
IMPORTANT SAFETY INSTRUCTIONS