Filter
Top Products
25
On-Screen Display Menu
Power Control Menu
Power control setting allows you to save energy.
Example
No Signal Off
No Operation Off
[Disable]
[Disable]
Power Control
1
Press MENU to display the MENU screen, and
then press
/ to select “Power Control”.
2
Press / to select a “No Signal Off” or “No
Operation Off”, and then press ENTER.
3
Press / to select “Enable”, and then press
ENTER.
4
Press MENU to exit.
No Signal Off
When set to “Enable”, the power will automatically
shut down if there is no signal for 15 minutes.
Five minutes before the power shuts down, the •
remaining time displays every minute.
“Disable” is the factory preset value.•
You can view TV broadcasts on the LCD Monitor if you •
use external equipment such as a TV tuner. Be aware
that the “No Signal Off” function may not work even
when the TV program you are viewing finishes.
No Operation Off
When set to “Enable”, the power will automatically
shut down if there is no operation for 3 hours.
Five minutes before the power shuts down, the •
remaining time displays every minute.
“Disable” is the factory preset value.•
Setup Menu
Example
EZ Setup
Input Skip
Position
Language
Identification
Reset
[English]
Setup
1
Press MENU to display the MENU screen, and
then press
/ to select “Setup”.
2
Press / to select a specific adjustment
item, and then press ENTER.
3
Press / (or / ) to select the desired
setting, and then press ENTER.
4
Press MENU to exit.
EZ Setup
This function allows you to change the preset
values.
Language: Select from among 4 languages (English,
German, French and Spanish).
Monitor Location: Select “Home” or “Store” for the
location where you plan to install the LCD Monitor.
If you select “Home”, AV MODE is set to •
“STANDARD”.
If you select “Store”, AV MODE is set to •
“DYNAMIC (Fixed)”.
See “Initial Setup” on page 17 for setting each item.•
Input Skip
This setting allows you to skip the HDMI or PC-IN
Input (“Input 4”, “Input 5”, “Input 6” and “Input 7”) on
the Input Selection operation.
Yes: Skips the input.
No: Does not skip input.
Input Label
Lets you set the input terminal displayed when
using the INPUT SOURCE menu. Press
/ / / to select the new name for the input
mode.