Filter
Top Products
42
DSR Series
DATA No.4/BIT-3 : REVIEW
BIT-3 will be set to “1” when the DEVICE is in the REVIEW mode.
DATA No.4/BIT-2 : AUTO EDIT
BIT-2 will be set to “1” when the DEVICE is in the AUTO EDIT mode.
DATA No.4/BIT-1 : PREVIEW
BIT-1 will be set to “1” when the DEVICE is in the PREVIEW mode.
DATA No.4/BIT-0 : PREROLL OR CUE UP
BIT-0 will be set to “1” when the DEVICE receives the “20.30 : PREROLL” and “24.31 :
CUE UP WITH DATA” commands, and goes into the PREROLL and CUE-UP mode, and
BIT-0 will be also set to “1” when the PREROLL is performed in the AUTO EDIT or PRE-
VIEW mode.
DATA No.5
DATA No.5/BIT-6 : INSERT
DATA No.5/BIT-5 : ASSEMBLE
DATA No.5/BIT-4 : VIDEO
DATA No.5/BIT-2 : TIME CODE (LTC)
DATA No.5/BIT-1 : A2 (AUDIO CH-2)
DATA No.5/BIT-0 : A1 (AUDIO CH-1)
When the DEVICE receives the “4X.30 : EDIT PRESET” commands, the corresponding bit
of DATA No.5 will be set to “1” according to the state of the DATA-1 of the EDIT PRESET
command.
Refer to “4X.30 : EDIT PRESET”.
DATA No.7
DATA No.7/BIT-7 : VAR MEMORY MODE
BIT-7 will be set to “1” when the DEVICE receives the “40.47: VAR MEN ON” command,
and goes into the VARIABLE MEMORY mode.
DATA No.7/BIT-6 : VAR MEMORY ACTIVE
BIT-6 will be set to “1” when the DEVICE goes into the VARIABLE MEMORY mode by the
“40.47: VAR MEN ON” command and the information is stored in the VAR MEMORY.
DATA No.7/BIT-5 : AUDIO SPLIT
BIT-5 will be set to “1” when the DEVICE receives the “40.45 : AUDIO SPLIT ON” com-
mand, and goes into the AUDIO SPLIT mode.
DATA No.7/BIT-0 : IN-OUT STATUS
BIT-0 will be set to “1” when the DEVICE is in the PREVIEW or AUTO EDIT mode and the
tape is running between the IN point and OUT point.