Filter
Top Products
59
DSR Series
Limitations of VFL NAME
In the DSR-DR1000, the VFL NAME that creates problem in the system configuration cannot be used as
shown below.
. The host system that performs the VFL downloading cannot specify “default.dlt” or “cliplist0.dlt”or
“RepeatTmp.dlt” as the VFL NAME. (The filenames from which [.dlt] is deleted from the above-
described NAMEs cannot also be used.) At the same time, “00XXX” that is used as the name of Clip in
the DSR-DR1000 cannot also be specified.
. For the files using [*], up to 16 characters in the range of 20 to 4 can be used because [.dlt] is added
later inside the system. ([*] means wild card.) A maximum of seven VFLs can be registered. If any
VFL that uses the already registered VFL NAME, the existing VFL will be overwritten when it is
downloaded and saved.
STATUS processing
Statuses of the VFL DOWNLOAD DATA SET in the DSR-DR1000 are shown below.
SYSTEM STATUS Value Description
Command Status 0x41 VFL DOWNLOAD DATA SET
Execution Status 0x00 COMPLETE
0x01 IN PROGRESS
0x02 FAIL
0x03 FAIL, ILLEGAL DATA
0x04 FAIL, CURRENT_STATUS ERROR
0x21 FAIL, FILE IS NOT EXIST
0x26 FAIL, TIME CODE IS OUT OF RANGE OF THE FILE
0x28 FAIL, LACK OF RECORD ENTRY
(3) VFL DOWNLOAD DATA WRITE
In the DSR-DR1000, the VFL DOWNLOAD DATA WRITE command is used to register the Playlist
that is created on the basis of the VFL NAME and VFL TEXT that are specified by the VFL DOWN-
LOAD DATA SET command.
Command format
Item Size Value Description
DC 1 0xXX Data Count
CMD1 1 0x10 Command1
CMD2 1 0x42 Command2
DATA1 1 0xXX DRIVE ID
DATA2 n 0xXX.. VFL NAME
DRIVE ID 0x00 only
VFL NAME No processing is executed even if it is specified.
Statuses of the VFL DOWNLOAD DATA WRITE command in the DSR-DR1000 are shown below.
SYSTEM STATUS Value Description
Command Status 0x42 VFL DOWNLOAD DATA WRITE
Execution Status 0x00 COMPLETE
0x01 IN PROGRESS
0x02 FAIL
0x03 FAIL, NOT REGISTRATION