Filter
Top Products
Adjustment Using the Menus
18
USER CONFIG menu
You can select a language, etc.
Items that cannot be adjusted depending on the input
signal are displayed in blue.
Scan mode image
Submenu Setting
RGB/COMP SEL When a signal input via the IN
(input) connector of the RGB/
COMPONENT connector is being
monitored, based on the signal
being input, select RGB or COMP.
COMP LEVEL Select the component level from
among three modes.
• SMPTE for 100/0/100/0 signal
• BETA 0 for 100/0/75/0 signal
• BETA 7.5 for 100/7.5/75/7.5
signal
NTSC SETUP Select the NTSC setup level from
two modes.
The 7.5 setup level is used mainly
in North America. The 0 setup level
is used mainly in Japan.
GAMMA Selects the appropriate gamma
mode. You can select from among
5 settings. When “3” is selected,
the setting is roughly same as the
gamma mode of the CRT (2.2).
FORMAT DISP Select the display mode of the
signal format.
• ON: The format is always
displayed.
• OFF: The display is hidden.
• AUTO: The format is displayed
for about 10 seconds when
the input of the signal
begins.
LANGUAGE You can select the menu or message
language from among seven
languages.
• ENGLISH: English
• DEUTSCH: German
• FRANÇAIS: French
• ITALIANO: Italian
• ESPAÑOL: Spanish
• : Japanese
• : Chinese
x RGB/COMP SEL xxxx
· COMP LEVEL xxxxx
· NTSC SETUP x
· GAMMA x
· FORMAT DISP xxx
· LANGUAGE xxx
USER CONFIG (1/2) Rr
xSCAN xxxx
· PIC DELAY MIN xxx
USER CONFIG (2/2) Rr
SCAN Enlarge a 4:3 aspect ratio picture to
a 16:9 aspect ratio picture.
Select from “OFF” and “ZOOM”
mode.
PIC DELAY MIN Selects to set the delay by the
picture processing to the minimum
level when the signal is input.
• OFF: Mode for giving
precedence to the picture quality
(recommended mode). It takes
longer than “ON” for processing
the picture.
• ON: The processing time is
short. Line flicker and after-
image may be displayed.
Input
NORMAL
SCAN (5 %
OVERSCAN)
UNDER
SCAN
ZOOM
–
Submenu Setting
4
3
16
9
Output
3
4
9
16