Filter
Top Products
24
5
3
1 Insert a recordable MD.
2 Turn FUNCTION on the amplifier until
the desired sound source (i.e., TUNER)
to record appears.
3 Press z REC on the MD deck.
The MD deck stands by for recording.
4 Start playing the desired sound source
to record.
5 Press ENTER/YES at the desired point
to start recording.
Recording of the sound source starts with the
6 seconds of audio data stored in the buffer
memory.
If you use a partially recorded MD, recording
starts after the recorded tracks.
To stop Time Machine Recording
Press s on the MD deck.
Note
The MD deck starts storing audio data when the deck
stands by for recording in step 3 and you start playing
the source. If less than 6 seconds have passed when
you press ENTER/YES, Time Machine Recording
starts with less than 6 seconds of audio data.
Marking track numbers
You can mark track numbers as follows:
• Automatically during recording
Track numbers are automatically marked as on the
original source during recording from this
system’s CD player (CMT-SP55TC) or
components connected to the DIGITAL
OPTICAL AUX IN jack. Use the Level Synchro
Recording function to automatically mark track
numbers during recording from this system’s
tuner, tape deck or components connected to the
AUX IN jacks.
• At any point during recording
You can mark track numbers while recording any
sources.
• After recording
Use the Divide function (see page 35).
Marking track numbers
automatically during
recording
— Level-Synchro Recording
The Level Synchro Recording function is factory
set to on, so the track numbers are automatically
marked. If “LEVEL-SYNC” does not appear
during recording, turn on the Level Synchro
Recording as follows. Track numbers are
automatically marked when the input signal is
continuously below a certain level for more than
two seconds and then exceeds that level.
Note
You can not mark track numbers automatically if the
sound source to be recorded is noisy.
Starting recording with 6
seconds of prestored audio data
(continued)