Filter
Top Products
The TechniSat WERRA 1 is now searching for a station with the same
programme type. It stops on the first station which corresponds to the selected
programme type.
If no station can be found within the selected programme type the station
which has been selected before will be adjusted.
- The station which has been found can then be stored for the selected
frequency range as described under “Automatic station search“.
SCAN function:
Thanks to the SCAN function it is possible to get a general idea of the stations
which can be received at that time.After activating this function the adjusted
reception range (see 3.2.1) will be searched through.The frequency run stops
on every station which can be found and reproduces each station for 6
seconds.
Activation:
- Shortly push the button.
“SCAN“ is shown on the display and the function starts to work.
Finishing:
- Shortly push the button again.
The device is now tuned to the station which has been received before.
This one can then be stored as described under “Automatic Tuning
System“.
SCAN
SCAN
A short push on the respective button will change the frequency by 0.05 MHz;
when the button is pushed and held for a longer time the frequency runs until
the button is released.
Storing the station:
- Store the station as described in the chapter “Automatic station
search“.
Station search by programme type
Some stations with RDS also broadcast an identification of the programme
type (e.g.CLASSIC, POP,...).Thanks to this function it is possible to search for
stations of a special programme type:
- Shortly push the button.
The programme type of the adjusted station is displayed.The indication
“NO PTY“ means that this programme does not broadcast any
programme type identification.
- Push the buttons or possibly several times, to set the desired
programme type.
- Push the button for approx.2 seconds until a signal tone can be
heard.
PTY
>>
<<
PTY
14
3 Detailed instructions 3 Detailed instructions
Shortly push
PTY
Hold PTY for
approx.2 sec.
until signal can
be heard
S
t
e
p
1
S
t
e
p
3
S
t
e
p
2
Select the
programme
type
Select the desired programme position;
push button until signal tone can be
heard
S
t
e
p
1
REG
AST AFTP
PTY
Bed.Anl. Werra1 englisch 09.04.1998 11:54 Uhr Seite 14