3.1.4 Loudness function
When the volume is low the human ear perceives bass notes worse than middle
or high notes.In order to neutralize this effect the unit is equipped with a loudness
function increasing the loudness of the bass notes electronically.
This function can be switched on resp. off as follows:
- Push the button once to switch on.
- To switch off, push the button once more
When loudness is switched on the letters “LOUD“ are shown on the display.
The loudness function can also be switched on/off permanently if you proceed
as follows:
- Push the button for more than 4 seconds.
The letters “2 SPKRS“ or “4 SPKRS“ are indicated on the display.
- Push the button once.
The message “LOUD ON“ or “LOUD OFF“ is displayed,
depending if the function is switched on or off.
- Push the button to switch the function on or off.
The selected state is shown on the display.
After approx.6 seconds the device changes to normal operation again.The
modification is now stored.
BAND
>>
SEL
LOUD
LOUD
3.1.5 Calling the basic settings
By using the reset function the modifications according to chapter 3.1.3 can be
removed with one single push. The settings are then set to a mean value.
Furthermore, a loudness which may have been switched on is now being
switched off.
To carry out the reset proceed as follows:
- Push the button for approx.4 seconds until “RESET“ appears on the
display.
The function described above is thus effected.
3.1.6 Mode switching
When a cassette is inserted the mode automatically changes to cassette
operation.As described below you can change between radio and cassette.
Consequently,when you want to listen to the radio the cassette may stay in
the cassette slot.If a CD changer is connected you can also select this one.
To change the operating mode carry out the following step:
- Push the button,probably several times,until the desired operation
mode is set.
MODE
LOUD
8
3 Detailed instructions 3 Detailed instructions
S
t
e
p
1
S
t
e
p
2
S
t
e
p
3
S
t
e
p
4
S
t
e
p
1
Switch
on/off
loudness
Press for more than 4 sec.
Push once or
several times
Push once
to select
function
Switch
on/off
function
S
t
e
p
1
Push for
approx.4
sec.
REG
AST AFTP
PTY
Bed.Anl. Werra1 englisch 09.04.1998 11:53 Uhr Seite 8