Filter
Top Products
E6580772
12
3.1.3 Communication parameters
F10M communication parameters
Parameter name Title Setting value Details
Inverter number
f802
0 to 255 Sets inverter station address. (Note 1)
When using a message transmission, set the address of the
master station to 0 and address of the inverter station to 1 or
over.
Data type
selection
f830
0, 1 Selects type of transmitting and receiving data.
0: VFA7 mode
1:μs 250 mode
Input reference
setting 1
f831
Input reference
setting 2
f832
Input reference
setting 3
f833
Input reference
setting 4
f834
Input reference
setting 5
f835
Input reference
setting 6
f836
0 to 16 Sets scan transmission data to be received.
0: Without setting
1: Command
2: Speed reference value
3: Auxiliary speed reference value
4: Torque limit value
5: Positive torque limit value
6: Negative torque limit value
7: Torque command value
8: Synchronized torque bias
9: Tension torque bias
10: Load sharing gain
11: Drooping gain
12: Speed loop proportional gain
13: Speed loop accumulative gain
14: Terminal output data
15: Inertia moment ratio
16: Expansion command
Monitor output
setting 1
f841
Monitor output
setting 2
f842
Monitor output
setting 3
f843
Monitor output
setting 4
f844
Monitor output
setting 5
f845
Monitor output
setting 6
f846
0 to 16 Sets scan transmission data to be sent.
0: Without setting
1: Status
2: Operation frequency
3: Speed feedback value (real time)
4: Speed feedback value (1-second filter)
5: Internal torque reference value
6: Output amperage
7: Exciting amperage
8: Torque amperage
9: Overload accumulative value
10: Deleted torque of acceleration/deceleration torque
11: Motor counter data
12: Error code
13: Input terminal data
14: VI input
15: RR input
16: RX input