Filter
Top Products
E6580772
2
Warning
Prohibited
Do not install the inverter in any place subject to vibrations or it could fall.
Otherwise it can cause injury to people.
Wiring
Danger
Mandatory
▼ Be sure to perform the following preparatory work before proceeding to wiring.
① Turn the power off.
Wait 10 minutes or more after turning the power off and confirm that the charge lamp
(on the inverter) is extinct.
② Using a circuit tester that has a D.C. voltage measuring capacity of more than
800V, check to see that the voltage remaining in the D.C. main circuit (between PC
and PA) is below 45V.
Failure to do this preparation could lead to electric shocks.
Tighten the terminal board fixing screws at the specified torque.
Failure to do this could lead to fire.
About operation
Danger
Prohibited
Do not touch inverter terminals when they are energized even if the motor is halted.
Touching terminals while the power is energized could lead to electric shocks.
Do not wipe the body with a wet cloth.
It could lead to electric shocks.
Do not pull on the cable
It could cause damage or error.
About disposal of Inverter
Warning
Mandatory
Dispose of the inverter as an industrial waste.
Unless it is disposed of as an industrial waste, it will become risks for human
injury.