A SERVICE OF

logo

12-56 FIN AL DRIVE
Rear Axle
Apply the special grease slightly on the part [A] of the
band installation in order to make easy to install the boot
band.
Tighten the small boot band [B].
Tighten the boot band [A] and bend the tangs [B] securely
to hold down the end of the band.
Place the special grease tube nozzle in the bore of the
housing and squeeze the tube [A] until the grease comes
out from the joint bearing.
Tap the shaft end [A] straight with a plastic hammer until
it is locked by the circlip.
Squeeze all of the special grease [ A] into the new boot
[B], and slide the boot onto the outboard joint [C].