ELECTRICAL SYSTEM 17-69
Meter
•
Turn off the ignition switch.
•
Remove the seat (see Frame chapter).
•
Disconnect both sets of 4 pin connectors [A] in the elec-
trical parts case.
•
Reconnect these 4 pin connectors to their opposite gray
to black and black to gray as shown.
•
Turn on the i gnition switch.
•
Observe the belt check indicator light [A].
○
It should be f lashing quickly.
•
Disconnect the belt switch at the 2 pin connectors [A]
above the torque converter cover.
•
Observe the belt check indicator light.
○
It should be flashing slowly.
○
Let it flash for at least five seconds.
NOTE
○
More than five seconds is OK.
•
While observing the belt check indicator light, turn off the
ignition switch.
•
Disconnect the mismatched 4 pin connector sets and re-
connect them normally. (Black to black, gray to gray) [A]
