A SERVICE OF

logo

12-62 FIN AL DRIVE
Rear Final Gear Case
Remove the rear final gear case [A] as shown.
Rear Final Gear Case Installation
Install:
Rear Final Gear Case
Bracket [A]
Collars [B]
Bracket Bolts [C]
[D] Front
[E] Hole
Washers (rear side)
Apply a non-permanent locking agent (Three Bond
1363A, Red) to the rear final gear case nuts.
Tighten:
To rque - Rear Final Gear Case Nuts [F]: 72 N·m (7.3 kgf·m,
53 ft·lb)
Bracket Bolts: 59 N·m (6.0 kgf·m, 43 ft·lb)
Install:
Removed Parts (see applicable chapters)
Rear Final Gear Case Disassembly
Remove:
Rear Final Gear Case (see Rear Final Gear Case Re-
moval)
Rear Final Gear Case Right Cover Bolts (M8) [A]
Rear Final Gear Case Right Cover Bolts (M10) [B]
Rear Final Gear Case Right Cover Bolts (M12) [C]
Using the pry points [A], remove the rear final gear case
right cover [B].
[C] A rrow Marks
Remove:
Ring Gear
Shims