5: Commands and Levels
PremierWave XN Command Reference 152
Restores the default log output, which is disable.
Exits to the next higher level.
Sets the maximum size in Kbytes for the Log file.
Enables log to filesystem.
Enables log to serial line.
Shows the current configuration.
show history
Displays the last 20 commands entered during the current
CLI session.
Stores the current configuration in permanent memory.
modem (tunnel-modem:2) level commands
Sets the CONNECT string used in modem emulation.
<string> = connect string.
default incoming connection
Default disables incoming network connections.
Default uses text type responses.
display remote ip disable
The incoming RING has nothing following it.
The incoming RING is followed by the IP address of the
caller.
Does not echo modem commands.
Does not echo the +++ characters when entering modem
command mode.
Echoes the +++ characters when entering modem com-
mand mode.
error unknown commands disable
Returns OK on unknown AT commands.
error unknown commands enable
Returns an error upon unknown AT commands.
Returns to the tunnel level.
incoming connection automatic
Automatically answer incoming network connections.
incoming connection disabled
Disable incoming network connections.
incoming connection manual Wait for an ATA command before answering an incoming
Removes optional CONNECT string information for mod-
em emulation.
Asserts tunnel modem status with current configured val-
ues.
Uses numeric type responses.
Uses text type responses.
Displays the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Displays tunnel modem status.
Does not send Modem Response Codes.
Sends Modem Response Codes out on the Serial Line.
Stores the current configuration in permanent memory.
modem (tunnel-modem:1) level commands
Sets the CONNECT string used in modem emulation.
<string> = connect string.
default incoming connection
Default disables incoming network connections.
Default uses text type responses.
