52
Gateway-to-Gateway VPN Tunnel
Wireless-G VPN Router with RangeBooster
Appendix E
For the Local Security Group Type, select Subnet. Enter
the RV082’s local network settings in the IP Address and
Subnet Mask fields.
RV082 VPN Settings
For the Remote Security Gateway Type, select IP
address. Enter the WRV200’s WAN IP address in the IP
Address field.
For the Remote Security Group Type, select Subnet.
Enter the WRV200’s local network settings in the IP
Address and Subnet Mask fields.
In the IPSec Setup section, select the appropriate
encryption, authentication, and other key management
settings. (These should match the settings of the
WRV200.)
In the Preshared Key field, enter a string for this key, for
example, test1234.
RV082 IPSec Setup Settings
Click Save Settings.
Configuration of PC 1 and PC 2
Verify that PC 1 and PC 2 can ping each other (refer to
Windows Help for more information). If the computers
can ping each other, then you know the VPN tunnel is
configured correctly.
Configuration when Both Gateways Use
Dynamic IP Addresses
This example assumes both Gateways are using dynamic
IP addresses. If only the Remote Gateway uses a dynamic
8.
9.
10.
11.
12.
IP address, refer to “Configuration when the Remote
Gateway Uses a Dynamic IP.”
Dynamic IP: A.A.A.A
with Domain Name:
www.xyz.com
LAN: 192.168.5.1
Dynamic IP: B.B.B.B with
Domain Name: www.abc.com
LAN: 192.168.1.1
WRV200
RV082
Gateway-to-Gateway IPSec VPN Tunnel - Both Gateways Using
Dynamic IP
NOTE: Each computer must have a network
adapter installed.
Configuration of the WRV200
Follow these instructions for the first VPN Router,
designated WRV200. The other VPN Router is designated
the RV082.
Launch the web browser for a networked computer,
designated PC 1.
Access the web-based utility of the WRV200. (Refer
to “Chapter 5: Configuring the Wireless-G Router” for
details.)
Click the VPN tab.
Click IPSec VPN.
For the IPSec VPN Tunnel setting, select Enable.
Enter a name in the Tunnel Name field.
For the Local Secure Group Type, select Subnet. Enter
the WRV200’s local network settings in the IP Address
and Mask fields.
WRV200 IPSec VPN Settings
1.
2.
3.
4.
5.
6.
7.
