Filter
Top Products
17-EN
CD Player/Changer Operation (Optional)
Scanning Programs
1 Press the SCAN button to activate the Scan
mode.
The first 10 seconds of each track will be played
back in succession.
To stop scanning, press the SCAN button and
deactivate the Scan mode.
NOTES
When the monitor display is open: displayed in the monitor
display
• In case a 6-disc CD changer is connected:
In CD changer mode, press the FUNC button to light the
"FUNC" indicator in red and go to step 1.
• In case a 12-disc CD changer is connected:
In changer mode, press the FUNC button twice to light the
"FUNC" indicator in red and go to step 1.
When the monitor display is closed: displayed in the sub
display
• In case a 6-disc CD changer is connected:
In CD changer mode, press the FUNC button to illuminate
the "FUNC" indicator and go to step 1.
• In case a 12-disc CD changer is connected:
In changer mode, press the FUNC button twice to
illuminate the "FUNC" indicator and go to step 1.
Titling Discs
It is possible to title your favorite CD’s.
To display the Title display mode:
To title a disc, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow
the procedure below.
1. Push the foot brake to bring your vehicle to a
complete stop at a safe location. Engage the parking
brake.
2. Keep pushing the foot brake and release the parking
brake once then engage it again.
3. While the parking brake is being engaged the
second time, release the foot brake.
NOTE
For automatic transmission vehicles, place the transmission
lever in the Park position.
Now, the locking system for the Title display mode
operation has been released. Unless the ignition key is
turned to the OFF position, the Title display mode can
be activated by engaging the parking brake without
performing the above procedure (1 through 3).
Each time the ignition key is turned to the OFF
position, perform the above procedure.
NOTE
If you try to access this screen while driving, the warning-
CAN'T OPERATE WHILE DRIVING will be appeared.
1 When the monitor display is open, press the
TITLE button and select the title display mode.
For details, see Displaying the Title/Text (page
26).
2 Press and hold the TITLE button for at least 3
seconds. The first character will blink.
3 Press the g DN or f UP button to select
the desired letter/numeral/symbol available for
naming.
4 Press the :/J button to store the first character.
The first character will stop blinking and the
display will automatically advance to the next
character. When that character begins to blink,
you may choose the next letter or symbol of your
title.
5 Repeat the steps 3 and 4 above to complete the
titling. Pressing the :/J button after entering the
8th character, automatically stores the title into
memory.
When entering a title of less than 8 characters
(for example, 3 character title):
After entering 3 characters to complete your title,
the 4th character space will be blinking. Go to
step 6 to complete the title.
6 Press and hold the TITLE button for at least 3
seconds to record the title.
NOTES
• The memory can store up to 150 titles for CD changer.
If you try to store beyond the limit, the display will
show "FULL DATA." At this point, no more titles can
be stored.
• The CD Changer title length or memory capacity
varies depending upon the model being used.
• When you want to erase a title, enter the "
"
symbol into all spaces.
• The operations described in steps 3 to 5 must be made
within 10 seconds. The input mode will be cancelled if
no action is taken for over 10 seconds.
• Removing power from the unit may delete these titles.
Use caution when manipulating the power cord.