Filter
Top Products
ALPHA™ Wireless Data Receiver Installation Manual
13
ALPHA 7000 Series Data Receiver Setup (continued)
Step 3: After removing the Access Cover, find the Two-Prong Receptacle located at the
bottom of the EPROM:
Figure 17: The compartment under the Access Cover.
Step 4: Get the Jumper from your Data Receiver Kit. The
Jumper (right) is a small dark piece of plastic.
When installing the Jumper, be careful not to drop it inside the ALPHA 7000
Series case. If the Jumper falls inside. service may be required to remove it.
Step 5: Locate the Two-Prong Receptacle that is below the EPROM. If there already is a
jumper over these two prongs, then go to Step 6. Otherwise, place the Jumper
bottom over the two prongs. Then push down until the Jumper is secure:
Figure 18: Installing the Two-Prong jumper.
EPROM
Two-Prong Receptacle
Three-Prong Receptacle
Jumper top
Jumper bottom
STOP
Place the Jumper over these two prongs
(as shown here)