Filter
Top Products
ALPHA™ Wireless Data Receiver Installation Manual
16
ALPHA 300 Series Data Receiver Setup
Note: If you’re using an ALPHA 215 sign, go to page 2
If you’re using an ALPHA Big Dot® sign, go to page 5.
If you’re using an ALPHA 4000 Series sign, go to page 8.
If you’re using an ALPHA 7000 Series sign, go to page 12.
Step 1: Unplug the ALPHA sign from its outlet or power source. Make sure to unplug the
unit from the outlet, not the back of the sign.
Step 2: Insert the Data Receiver cable plug into the right Communications Port—the
RS232 port—on the back side of the sign:
Figure 21: Data Receiver cable installation.
Step 3: Remount the sign. Attach one side of the Velcro strips to the Data Receiver. Then
use the remaining Velcro to attach the Data Receiver directly to the wall next to
the sign. Use the 3-foot Extender Cable and Modular Plug to mount the Data
Receiver to the wall. The Data Receiver MUST be installed horizontally with the
LED light facing out. Restore the power.
Step 4: After power has been restored to the sign, the indicator light on the front of the
Data Receiver should be on.
Step 5: This completes the Data Receiver installation.
Insert Receiver cable
plug into the right
port (as shown here)