Filter
Top Products
ALPHA™ Wireless Data Receiver Installation Manual
4
ALPHA 215 News Service Setup (continued)
Step 6: Insert the Data Receiver cable plug into the Receiver Cable RS232 Port on the
back of the sign. Then place the cable in the Cable Groove:
Figure 5: Completed installation.
Step 7:
For Ceiling Hanging, Countertop, and Wall Mounting Brackets:
Install the Data Receiver (with its Access Cover Mount attached) over the
compartment opening on the back of the sign. Remount the sign and restore
power.
For Flush Wall Mounts
:
Reinstall the
original
Access Cover over the compartment opening on the back of
the sign. Remount the sign. Attach one side of the Velcro strips to the Data
Receiver’s Access Cover. Then use the remaining Velcro to attach the Data
Receiver directly to the wall next to the sign. The Data Receiver MUST be installed
horizontally with the LED light facing out. Restore the power.
Step 8: After power has been restored to the sign, the indicator light on the front of the
Data Receiver should be on.
Step 9: This completes the Data Receiver installation.