Filter
Top Products
ALPHA™ Wireless Data Receiver Installation Manual
6
ALPHA Big Dot® Data Receiver Setup (continued)
Step 4: Get the Jumper from your Data Receiver Kit. The
Jumper (right) is a small dark piece of plastic.
When installing the Jumper, be careful not to drop it inside the ALPHA Big Dot®
case. If the Jumper falls inside, service may be required to remove it.
Step 5: Locate the Two-Prong Receptacle that is below the EPROM. If there already is a
jumper over these two prongs, then go to Step 6. Otherwise, place the Jumper
bottom over the two prongs. Then push down until the Jumper is secure:
Figure 8: Where to install the Jumper.
Jumper top
Jumper bottom
STOP
Place the
Jumper
over these
two prongs.