Filter
Top Products
ALPHA™ Wireless Data Receiver Installation Manual
3
ALPHA 215 Data Receiver Setup (continued)
Step 4: Get the Jumper from your Data Receiver Kit. The
Jumper (right) is a small dark piece of plastic.
When installing the Jumper, be careful not to drop it inside the ALPHA 215 case.
If the Jumper falls inside, service may be required to remove it.
Step 5: Locate the Two-Prong Receptacle that is below the EPROM. If there already is a
jumper over these two prongs, then go to Step 6. Otherwise, place the Jumper
bottom over the two prongs. Then push down until the Jumper is secure:
Figure 4: Where to install the Jumper.
Jumper top
Jumper bottom
STOP
Place the
Jumper over
these two
prongs.