Filter
Top Products
-10-
If a problem should develop while operating the CD player, an error code (ER-1, ER-2, ER-3, etc.) may appear on the display
panel. This can indicate a number of problems with the unit, including a mechanical error or an error in the microprocessor
control of the player. If an error code should appear, try ejecting and re-loading the disc into the player. While the disc is out
of the unit, make sure it is clean, undamaged, and loaded correctly (label surface up). You may also try activating the
RESET button dm on the unit, but this will also erase the time and pre-set memories.
CD PLAYER ERROR CODES
SETTING THE CLOCK
1. Switch the vehicle ignition and radio “on”.
2. Press the Time/Frequency button to access the time display.
3. While holding the Time/Frequency button in, press the Down Tuning ( -) button to adjust the hours and AM/PM
indication or the Up Tuning (+ ) button to adjust the minutes to the correct time.
4. Five seconds after the last hour or minute adjustment is made, the time will be set in the unit and the display will return to
the normal indication.