Filter
Top Products
-6-
3. Press the pre-set button to be set and continue to hold it in
for approximately 2 seconds. The pre-set number will appear
on the display panel and two beeps will sound, indicating that
the station is now set into that pre-set memory position. The
station can now be recalled at any time by pressing that button.
4. Repeat the above procedure for the remaining 5 pre-sets on
that band and for the other 4 bands on the unit.
br LIQUID CRYSTAL DISPLAY PANEL
The Liquid Crystal Display (LCD) panel displays the frequency,
time, and activated functions.
NOTE: It is a characteristic of LCD panels that, if subjected to
cold temperatures for an extended period of time, they
may take longer to illuminate than under normal conditions.
In addition, the visibility of the numbers on the LCD may
slightly decrease. The LCD read-out will return to normal
when the temperature increases to a normal range.
bs FUNCTION DISPLAY
The Function Display consits of five bar graphs which provide a
visual representation of the volume level and the left and right
channel balance levels. The volume level is represented by three
thin bar graphs. As the volume is increased, the number of
illuminated segments will increase. The left and right channels
are represented by the wider bar graphs. As the strength of the
signal applied to either the left or right channel increases, the
number of illuminated segments will increase.
bt MODE SELECTOR (MOD)
This button is used to select the radio or the playback mode for
the CD player/changer. Each press of the button will select a
different mode as indicated on the display panel.
During integral CD player operation, this button may be used to
change to radio without ejecting the disc. The IN indication
will remain on the display panel to show that the disc is still
loaded in the unit. During remote CD changer operation, the
DISC number indication will remain on the display panel together
with the TRACK number being played, to show that the CD
changer is operating. Press the button again to return to radio
or integral CD player mode to resume play of the disc from the
point at which it was stopped.
bu DISC SLOT
With the front panel in the fold-down position, gently insert the
disc into the slot (label surface facing up) until the soft-loading
mechanism engages and pulls the disc in. The LOAD indication
will momentarily appear on the display panel followed by the total
playing time of the disc. The ( ) indication illuminates and
becomes animated, the IN symbol lights, and the track
number and elapsed time will appear on the display panel.
CAUTION: This unit is designed for play of standard 5"
(12cm) compact discs ONLY. Do not attempt to u se
3" (8cm) CD-Singles in this unit, either with or without
an adapter, as damage to the player and/or disc can
occur. Such damage will not be covered by the
Warranty on this product.
cl TRACK SELECT ( + / - )
During disc play the Track Select functions are used to quickly
access the beginning of a particular track. Each time the Forward
Track Select ( + ) side of the button is pressed, the next
higher track number will be selected as shown on the display
panel. Similarly, each time the Backward Track Select ( - )
side of the button is pressed, the next lower track number will be
selected as shown on the display panel.