Blaupunkt DVD-ME1 Car Video System User Manual


 
SAFETY CONCERNS
3
We always recommend you have your Blaupunkt DVD/MP3 player professionally installed but the installation process is
often so easy that the average consumer can achieve success with little trouble. All operating instructions should be
followed. Regardless of person installing, you should be sure to review the following points before proceeding with the
installation:
READ THE MANUAL! Understanding the product and installation limitation before lifting a screwdriver. Follow
Instructions -
POWER SOURCES - Make sure to use operate only from the type of power source indicated on the rear panel. For
products intended to operate from battery power, or other sources, refer to the operating instructions. Do not overload
the power source to prevent a risk of fire or electric shock.
POWER LINES - An outside antenna system should not be located in the vicinity of overhead power lines or other
electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna
system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might
be fatal.
POWER CABLE - Make sure to route power cables appropriately so that they are not likely to be walked on or pinched
by items placed upon or against them, paying special attention to cords at plugs, convenience receptacles, and the
point where they exit from the product.
CLEANING - Disconnect this product from the power source before cleaning. Do not use liquid cleaners or aerosol
cleaners. Use a damp cloth.
WATER & MOISTURE - Do not use this product near water.
ACCESSORIES - Do not place this product on an unstable object. Any mounting of the product should follow the
manufacturer's instructions, and should use a mounting accessory recommended by the manufacturer.
LIGHTNING - During a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from
the power source prevent damage to the product due to lightning and power-line surges.
OBJECT & LIQUID ENTRY - Never push objects of any kind into this product and/or liquid entry to product could result
in a fire or electric shock.
SERVICING - Any attempt to service this product yourself as opening or removing covers may expose you to
dangerous voltage or other hazards.
DAMAGES REQUIRING SERVICE - Disconnect this product from the power source and refer servicing to qualified
service personnel under the following conditions;
a) Damage to the power cord or plug
b) Water damage
c) Product malfunction or change in performance
d) If the product has been dropped
PART REPLACEMENT - Make sure to use the replacement parts specified and/or approved by the manufacturer to
prevent potential fire, electric shock or other hazards. Upon completion of any service or repair, be sure to perform
safety checks by qualified service personnel.
WEAR SAFETY GLASSES AT ALL TIMES - Flying debris are always dangerous.
PROTECT THE VEHICLE - Always disconnect the negative battery cable before starting any kind of installation work.
This prevents a possible high current electrical short (potential fires).
HEAT - Keep all products away from nearby hot components such as amplifiers, radiators, heat registers, stoves or
vehicle components that heat up over time such as hoses, high current wires, and braking systems components.
Make sure to leave enough room for ventilation on openings and slots to protect if from over-heating.
GIVE YOURSELF LOTS OF TIME - Rushing to complete an installation nearly always ends up with problems.
WHILE DRIVING, KEEP EYES ON THE ROAD AND NOT ON THE MONITOR. KEEP THE VOLUME LOW.
Please record the model and serial number located at rear panel.
Model No. Serial No.