No power: Check power connection to the unit +12 volt, ground, and remote lines. Use voltmeter to
verify voltages are at terminals of the unit.
No picture: Check video cable connection, color adjustment, and monitor operation.
No sound: Check audio cables connection, amplifier or source connection to set receiving DVD signal
output. Check audio mode setting.
Image distortion: Check signal system (NTSC, PAL, AUTO). Eject the disc and clean it.
Remote control trouble: Check batteries. Point the remote control at the remote control sensor of the unit.
No disc playback: Make sure insert a playable disc (check the disc type, region code and color system).
Place disc playback side down in the proper guide. Clean the disc. Cancel or change the
parental lock function. (The factory pre-set is 99999.) Turn power switch or power
connection on and off.
TROUBLESHOOTING
■
This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents
and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright
protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited
viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is
prohibited.
■
Manufactured under license from Dolby Digital Laboratories. "Dolby" and the Double-D symbol are trademarks of
Dolby Laboratories. Confidential unpublished works. (c) 1992-1997 Dolby Laboratories, Inc. All rights reserved.
■
DTS and DTS Digital Out are trademarks of Digital Theater System, Inc.
NOTE ON COPYRIGHT
TECHNICAL SPECIFICATIONS
– 6 –
Power supply DC12V, 1.5A
Power Consumption ≤ 20W
Operating Temp. 5˚C to 35˚C (41˚F to 95˚F)
Dimensions 170 x 73 x 215 mm (W/H/D)
Weight 1.4Kg
Signal system NTSC (US)/PAL/AUTO
Laser Wavelength 650nm
Audio Output (Analog) Output level: 1.5 ± 0.25V
Load impedance: 10KΩ
Video output Output level: 1 ± 0.2V
Load impedance: 75Ω
Headphone out Jack type: Ø 3.5mm headphone jack
Frequency response 10Hz~20KHz ± 0.5dB
Signal/noise ratio ≥ 110dB (“A” weighted)
Audio distortion + noise ≤ -70dB (1KHz)
Channel separation ≥ 85dB (1KHz)
Dynamic range ≥ 90dB (1KHz)
Audio cable (red and white, 18 ft.) 1 pair
Video cable (white, 18 ft.) 1
Remote control 1
AAA batteries 2
External remote sensor 1
Face bezel 1
DC 12V Power cord (mobile) 1
AC adapter Input: 100-240V~30W 50/60Hz 1
Output: DC 12V 1.5A (home)
Mounting brackets 2
(horizontal & trunk mount)
Mounting screws 8
Protecting pad 1
Noise filter for power source 1
Owner's manual 1
Supplied Accessories