Filter
Top Products
40
Manual tuning:
• Press << >>; the frequency will change
in short intervals in the downwards or
upwards direction.
If you hold << >> pressed to the left or the
right on the rocker switch, the frequency
scan will speed up.
Scrolling through the broadcast-
ing networks (FM only)
You can use the << >> buttons to tune into
stations in your reception area.
If it is possible to receive several pro-
grammes in the same broadcasting network,
you can scroll through them in the forwards
direction by pressing >>, or backwards us-
ing the << button, e.g. NDR 1, 2, 3, 4, N-
JOY, FFN, ANTENNE ... .
For this to work properly you must have al-
ready tuned into the stations at least once
and “AF” must be active (lights up in the dis-
play).
To do this, you can start the Travelstore seek
operation:
• Press BND for 2 seconds; the system
will start to run through the frequency
band.
would like to take advantage of full RDS
service, switch to “REG OFF”.
• Press the AF button for approximately
2 seconds until “REG OFF” appears.
“REG ON” or “REG OFF” will appear briefly
in the display each time the radio is switched
on.
Selecting a waveband
With this car radio you can select between
the following wavebands:
FM 87.5 - 108 MHz
MW 531 - 1602 kHz
LW 153 - 279 kHz
• Select the desired waveband by press-
ing the BND button.
Note:
In the DSC menu it is possible to block MW
or LW or both wavebands for station selec-
tion.
The advantage of doing this is that only the
required wavebands can be selected and it
is no longer necessary to press BND so of-
ten. If necessary, refer to the section on
“DSC programming – AM ON or AM OFF”.
Station tuning
Automatic tuning /
• Press / ; the car radio will automati-
cally search for the next station.
If you hold / pressed up or down on the
rocker switch, seek tuning will speed up in
the upwards or downwards direction.
Seek tuning
Up
Down
<< / >> Up/down in short intervals
(for FM only, “AF” must be switched off)
Manual tuning with << >>
You can also tune into a station manually.
Requirement:
AF and PTY must be switched off (i.e. the
symbols do not light up in the display).
If necessary, deactivate these functions:
• Press AF or PTY.