Blaupunkt RD 148 Car Stereo System User Manual


 
31
ENGLISH DEUTSCHFRANÇAISITALIANO
NEDERLANDS
SVENSKAESPAÑOL
PORTUGUÊS
To programme the mute volume level,
proceed as follows:
Set the desired volume.
Press
for 2 seconds until you
hear a beep.
Now this volume level is stored as your
mute volume.
Extra function
Press to store settings made in the
DSC menu.
4 SC - Scan
Radio operation
Scan
Press SC briefly -
“FM SCAN” will alternate with the ab-
breviated name of the scanned station
in the display. The unit will scan all of
the FM stations in the current recep-
tion range.
Preset Scan
Preset Scan cannot be started unless
PTY has been switched off (“PTY”
does not light up in the display).
Press SC for approximately 2 seconds
until you hear a beep.
Switching on when the ignition is
switched off:
To keep on operating the set when the
ignition is switched off (KeyCard is in-
serted), proceed as follows:
Press ON after you hear the double
beep tone.
The unit will turn on.
To prevent the battery from going
dead, the system will turn off automati-
cally after it has played for one hour.
2 VOL+ / VOL-
Alters the volume.
Each time the set is switched on, it will
play at the pre-adjusted volume (VOL
FIX).
You can also change the VOL FIX set-
ting (see the section on “DSC pro-
gramming”).
3
Instantly mutes the volume.
Press the
button to mute the volume
immediately. “MUTE” will appear in the
display.
Cancel the function by pressing button
or VOL+.
If you press VOL-, the normal volume
will be the same as the mute volume.
Quick reference
1 Switching on/off with the buttons:
Press one of the buttons illustrated
here after you have inserted the Key-
Card.
The unit will play at the pre-adjusted
volume.
Switching on/off with the KeyCard:
The set is switched on or off by insert-
ing or removing the KeyCard.
Note:
Be sure to read the information in the
section on “KeyCard theft protection
system”.
Switching on/off via the ignition:
If the equipment has been connected
correspondingly, the set can also be
turned on and off with the vehicle igni-
tion.
After the ignition has been switched
off, a double beep tone will remind you
that you should remove the KeyCard
before leaving your vehicle.