Filter
Top Products
50
Deactivating the hour correction
function
In the DSC menu it is possible to switch off
the hour correction function with “CLK MAN/
CLK AUTO”. An automatic correction for
minutes will continue to take place.
This is useful if you would like to display the
time for a different time zone, for example.
If necessary,
• Press DSC briefly and
• Press
/ as often as required until
“CLK MAN/CLK AUTO” appears in the
display.
To deactivate the hour correction function
press << >> to select “CLK MAN”.
• Press << >> to set the hours/minutes.
Displaying the clock
You can set the clock to permanent display
in both the radio and CD modes.
If another function is selected, the clock dis-
play will disappear for approximately 8 sec-
onds and the station selected, for example,
will appear in the display.
To switch the display mode:
• Press LD for approximately 2 seconds.
Correcting the clock after the
power has been disconnected
If the radio has been disconnected from its
power source for a longer period of time,
“0:00” will appear in the display when it is
re-connected.
The time will be set automatically by RDS-
CT, but can also be adjusted manually if
desired.
You need only set the time manually if it is
not possible to receive an RDS station with
CT (clock time).
Warning note
Danger of damaging the automatic
power antenna in a car wash
If your vehicle is equipped with an automat-
ic power antenna, it might still remain fully
extended after you have turned the radio off
in order to synchronise the time with DCF
77.
Before you drive into a car wash
• switch the radio off by pressing the ON
button.
The power antenna will retract, if it
doesn’t, press ON again.
DCF 77 will remain inactive for as long as
the radio is switched off.
Do not drive into the car wash unless
the power antenna has retracted!
After you leave the car wash “DCF 77” will
reactivate when you switch the radio on
again.