Filter
Top Products
18
has been completed, the radio will play the
station with the strongest reception (ST 1).
If desired, stations can also be stored man-
ually on the Travelstore bank (see “Storing
stations”).
Recalling stored stations
You can recall any stored station at the touch
of a button.
FM
Recall the stations on the memory bank
selected directly:
• by pressing ST1 - ST6.
To select a station on a different bank:
• Press NEXT as often as necessary un-
til the desired memory bank appears
and then select the station by pressing
ST1 - ST6.
• Press the desired preset button until
the radio resumes play after the muting
(takes approximately 2 seconds, con-
firmed by a beep).
Now the station has been stored.
Note:
Should you tune into a station which has
already been stored before on another mem-
ory bank, the corresponding preset button
and the memory bank will flash briefly in the
display.
Automatically storing the
strongest stations with Travel-
store
You can automatically store the six most
powerful FM and AM stations in your cur-
rent reception area sorted according to their
signal strength. This function is particularly
con-venient on longer trips.
• Press TU, menu level 2 will appear in
the display.
• Press TS briefly.
“T-STORE” will flash in the display.
The six strongest FM or AM stations will be
automatically stored on the memory bank T
(Travelstore). If it is not possible to receive
six stations, the remaining presets will be
marked by four dashes. When this process
AM
You can select the stations stored for the
selected bank directly:
• by pressing ST1 - ST6.
To select a station on a different bank:
• Press NEXT as often as necessary un-
til the desired memory bank AM or
AMT appears and then select the sta-
tion by pressing ST1 - ST6.
Scanning stored stations with
Preset Scan
You can have all of the stored stations briefly
scanned on all bands and in the selected
FM memory bank.
Preset Scan cannot be started unless PTY
is switched off (“PTY” is not highlighted in
the display).
If necessary, switch off PTY on menu level
2. To do so
• press TU and switch off the function by
pressing the corresponding key.
To start Preset Scan:
• Press SCA for approx. 1 second.
All of the stored stations on the band se-
lected and within reception range will be
scanned one after the other. “SCAN” and
the station name or frequency will flash al-
ternately in the display.
Radio operation with RDS (Radio Data System)